Ads-environmental-services IntelliServe 2.8.1 950026A7 Manuel d'utilisateur télécharger pdf (Page 99)

Data Presentation 5-25

CONFIDENTIAL – Covered by ADS Terms of Use and Confidentiality Agreement in Contract

Note: These curves are based on only the last seven days of collected

data; therefore, may not be accurate for earlier time periods.

9. From the Depth drop-down list, select the type of depth you want to graph

against velocity. DProcessed is the default and recommended depth entity

for viewing.

Note: Several data entities fall under common root entity types and,

therefore, share common root entity names. To expedite and simplify

the entity selection process, the Available Data Entities table lists

these unique root entity names, in place of the individual entity names,

to collectively represent the corresponding entities sharing the common

root names. Selecting a root entity name causes IntelliServe to plot all

the data available for the entities associated with that root entity type for

the selected monitoring points. For example, consider IntelliServe

supports several pressure depth entities (such as PDEPTH, PDEPTH_1,

and PDEPTH_2) that share the same root name (PDEPTH), but may

have different identifiers (numbers following the root name).

Consequently, the entity available for selection from the Available

Data Entities table under this configuration would be PDEPTH, but

IntelliServe would plot all available PDEPTH, PDEPTH_1, and

PDEPTH_2 data on the scattergraphs.

10. In the Min Value and Max Value fields, modify the default minimum and

maximum values you want to use to plot the selected depth. These fields

both default to 0.

Note: If 0 is in the Max field, the x-axis automatically scales to the

highest depth reading recorded at the monitoring point for the selected

date range or the pipe height of the location, whichever is greater.

11. Select the velocity type you want to graph against the selected depth from

the Velocity drop-down list. VProcessed is the default velocity entity and

the recommended velocity entity for viewing.

12. In the Min Value and Max Value fields, modify the default minimum and

maximum values you want to use to plot the selected velocity-to-depth

relationship.

Note: Entering 0 in the Max field auto-scales the y-axis to the highest

velocity reading recorded at the monitoring point for the selected date

range.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 289 290

Pas de commentaire

Ads-environmental-services IntelliServe 2.8.1 950026A7 Manuel d'utilisateur Page 99